Before You Start
- Use a Chromium-based browser (Chrome, Edge, Brave, etc.)
- Unplug the board from your Flipper Zero first
- Have a USB cable ready to connect the board to your computer
- Don't touch or unplug the device during the update process
Video Tutorial
Note: When selecting the board, look at the Sacred Labs section and pick your board.
Step-by-Step Instructions
Disconnect and Connect
Unplug the board from your Flipper Zero and connect it directly to your computer using a USB cable.
Tip: Make sure you're using a data cable, not a charging-only cable.
Go to FzeeFlasher
Navigate to the FzeeFlasher website using a Chromium-based browser:
FzeeFlasher WebsiteRequired: Chrome, Edge, Brave, or other Chromium-based browser
Connect Device
Click the "Connect" button on the left side of the website and select your device from the list.
Device Not Recognized?
If your computer doesn't recognize the board, you may need to install the CH340 driver:
Only install drivers if your board isn't getting recognized. Skip the driver download if connection works.
Select Board Configuration
After selecting your device, configure the firmware options:
Flash Firmware
Click the "Program" button to start the update process.
Important During Flashing
- Don't unplug the device
- Don't touch the device
- Don't close the browser tab
- Wait for the process to complete
The flashing process typically takes 2-5 minutes. You'll see progress indicators showing the update status.
Verify Update
Once the flashing is complete:
- Disconnect the board from your computer
- Reconnect it to your Flipper Zero
- Test the Marauder functionality
- Check the version in the Marauder interface
Firmware Compatibility
The Ultra V3, Combo, and Mini boards use the ESP-WROOM-32UE chip. When looking for compatible firmware, ensure it supports this specific ESP32 variant.
Alternative Firmware
While Marauder is pre-loaded and recommended, you can flash other ESP32 firmware that's compatible with the ESP-WROOM-32UE chip. Always verify compatibility before flashing.
Troubleshooting
If you encounter issues during firmware installation, try these solutions:
- Try a different USB cable (ensure it's a data cable)
- Install CH340 drivers (links provided in step 3)
- Try a different USB port
- Restart your browser
- Ensure you selected the correct board type
- Try holding the "B" or "Boot" button while connecting
Legal Notice
Always ensure you are following the laws and regulations of your area when using all components. Only test on networks and devices you own or have explicit permission to test. The user is fully responsible for complying with all applicable laws and regulations.